DMA Memory to Memory mode is not working in STM32F103C8

0

I am trying to copy array using DMA MEM2MEM mode in STM32F103C8

But when i run this below code, the dest array still remains empty, no interrupt event fired

Please give me solutions or notice me if i missed any config, thanks very much

My code:

uint32_t source[MEMSIZE];
uint32_t dest[MEMSIZE];

for (i = 0; i < MEMSIZE; i++) {
    source[i] = i;
}

//Reset CCR and CNDTR register 
DMA1_Channel1->CCR &= ~0x7FFF;
DMA1_Channel1->CNDTR &= ~0xFFFF;
/*
* DMA configure:
* MEM 2 MEM: Enabled
* Priority: Medium
* Memory size: 32 bit
* Peripheral size: 32bit
* Memory increment: ON
* Peripheral Increment: ON
* Circular: OFF
* Direction: Copy from peripheral
* Transfer error IR: OFF
* Haft Transferred IR: OFF
* Transfer complete IR: ON
* Channel Enable: OFF
*/
DMA1_Channel1->CCR |= 0x00005AC2;
// Setting number of data
DMA1_Channel1->CNDTR |= MEMSIZE;
// Setting Peripheral address
DMA1_Channel1->CPAR = (uint32_t)source;
// Setting memory address
DMA1_Channel1->CMAR = (uint32_t)dest;
// NVIC setup
NVIC_SetPriority(DMA1_Channel1_IRQn, 0);
NVIC_EnableIRQ(DMA1_Channel1_IRQn);
// Enable DMA channel
DMA1_Channel1->CCR |= 0x00000001;

Update: I tried using GPIO ODR instead of array address for memory, and thats works perfectly

c
embed
stm32
dma
asked on Stack Overflow Feb 5, 2020 by Nguyen Minh • edited Feb 6, 2020 by Nguyen Minh

1 Answer

0

I'm unable to detect the problem in your code, but I created a minimal example on Blue Pill board. I checked the values in dest array in a debug session. The code seems to work as expected.

#include "stm32f1xx.h"

#define MEMSIZE 32

uint32_t source[MEMSIZE];
uint32_t dest[MEMSIZE];

int main(void) {

    RCC->AHBENR |= RCC_AHBENR_DMA1EN; // Enable DMA clock

    // Initialize the test data
    for (int i = 0; i < MEMSIZE; ++i) {
        source[i] = i;
    }

    DMA1_Channel1->CCR |= DMA_CCR_MEM2MEM // Memory to memory mode
            | (0b01 << DMA_CCR_PL_Pos) // Medium priority
            | (0b10 << DMA_CCR_MSIZE_Pos) // Memory size: 32-bits
            | (0b10 << DMA_CCR_PSIZE_Pos) // Peripheral size: 32-bits
            | DMA_CCR_MINC // Memory increment is enabled
            | DMA_CCR_PINC; // Peripheral increment is enabled
    DMA1_Channel1->CPAR = (uint32_t) source;
    DMA1_Channel1->CMAR = (uint32_t) dest;
    DMA1_Channel1->CNDTR = MEMSIZE;

    DMA1_Channel1->CCR |= DMA_CCR_EN; // Start DMA transfer

    while (1) {

    }
}
answered on Stack Overflow Feb 7, 2020 by Tagli

User contributions licensed under CC BY-SA 3.0